beautypg.com

Remko – REMKO Condensate Catch Tray With Oil Separator User Manual

Page 10

background image

10

REMKO

WITH INTEGRATED OIL SEPARATOR

CONDENSATE CATCH TRAY

Install the outdoor unit on the wall-mounted console as follows:

1. Using suitable fastening material, install the unit on a wall designed to carry

the load. Make sure that the height at which it is installed above the floor is
adequate (above the expected snow level!).

2. Align the two wall rails in the distance of the mounting feet of the Outer part of

the same amount on the wall (dimension B). Grasp the distance B measured best
from the outdoor unit.

The clearance required between
the left and right wall-mounted
consoles is indicated by the
clearance B figure

Take the clearance B figure directly
from the outdoor unit between the
left and the right
wall-mounted consoles

Select the fastening material suitable for the wall to which the condensate catch tray is

to be fastened!

Install the wall-mounted console to the building only where structurally permitted.

Make sure when drilling to place anchors that there are no supply lines where you are

drilling.

The wall-mounted console must be fastened so that it can carry the weight of the unit.

Make sure that no vibrations are transferred to the masonry. If necessary, install

insulation (see accessory programme).

Refrigerant lines and electrical lines must be installed from the rear or from the right,

not from below!

NOTE

This manual is related to the following products: