REMKO Condensate Catch Tray With Oil Separator - Manual (Page 11)

11
3. Mark the locations of the holes for the dowel holes in the wall bars.
4. Drill the holes and fasten the wall bars with the corresponding wall dowel, the
mounting screws and sheet steel angles on the wall.
5. Align the wall bars and correct any irregularities the wall, so that the wall bars
hanging horizontal. Screw the Wall bars set and check everything for a tight fit.
6. Mount the bracket using the supplied T-head screws upper part of the wall bars
(see drawing on page 9).
7. Align the bracket so that they are in a horizontal position before be fixed.
8. Mount the crossbar between wall bar and bracket
(see drawing on previous page).
9. Mount the included brackets with vibrations dumpers on the both arms
under the picture below.
Tighten the screws only slightly onto the hand, so that the Distances can easily
bracket adjustment is need. The screws are easy to move by bars.
Mount the brackets with the vibrations dumpers at a distance of Mounting feet
of the outdoor unit (dimension T) on the arm.