REMKO MVT 600 DC - Manual (Page 9)

Operation
Regular care, maintenance and
observation of some basic points
will ensure trouble-free operation
and a long service life.
Care and maintenance
Prior to performing any
work, ensure the equipment
is isolated from the voltage
supply and secured to prevent
accidental switch-on!
CAUTION
Temporary Shutdown
1. Allow the indoor unit to run for
2 to 3 hours in air circulation
mode or in cooling mode at the
maximum temperature setting
in order to remove any residual
moisture from the unit.
2. Shut down the system using
the remote control
3. Switch off the voltage supply
to the unit.
4. Cover as much of the unit as
possible with plastic foil to
protect it against the weather.
Permanent Shutdown
Ensure that equipment and
components are disposed of
accordance with local regulations,
e.g. through authorised disposal
and recycling specialists or at
collection points.
Contact REMKO GmbH & Co. KG
or your contract partner for local
specialist companies near you.
Shutdown
Care
■
Ensure the unit is protected
against dirt, mould and other
deposits.
■
Clean the unit using a damp
cloth.
Do not use a jet of water.
■
Do not use any caustic, abrasive
or solvent-based cleaning
products.
■
When operating the fan, clean
the fins of the unit prior to long
shutdown periods.
Maintenance
■
It is recommended that
maintenance contract with
annual maintenance interval
with an appropriate specialist
company.
This ensures the operational
reliability of your equipment!
TIP
The compressor in the outdoor
unit is operated by means of
regulating the control board in the
outdoor unit.
The chapter on "Regulation" in
the manual for the outdoor unit
must therefore be observed.
Type of task
Checks/Maintenance/Inspections
Commissioning Monthly Six-monthly Yearly
General • •
Measure voltage and current
• •
Function compressor
• •
Check fan is functioning correctly • •
Dirt on liquefier
• •
Check refrigerant fill quantity
• •
Check condensation drain • •
Test insulation
• •
Check moving parts • •
Sealing test for refrigerant circuit • •
1)
The statutory regulations
require an annual sealing
test for the refrigerant circuit
in relation to the refrigerant
filling level. The inspection
and documentation is to be
carried out by corresponding
specialist engineers.
NOTE
1) see note
9