REMKO ATY 260 - Manual (Page 25)

Connection of interior unit
Make the connection as follows:
1. Remove the front of the unit,
as described in chapter „Device
installation“.
2. Select the diameter of the
connection line according to
regulations.
3. Connect the unit with the
power supply line and the
control line to the exterior unit
(see electrical wiring schematic).
4. Reassemble the unit.
Connection of interior unit
Terminal bar /
control bar
Connection of the
exterior unit
To connect the line, proceed as
follows:
1. Remove the unit cover.
2. Remove the side wall at the
connection.
3. Guide the line through the edge
protection ring of the fixed
connection plate.
4. Connect the line according to
the wiring schematic.
5. Anchor the line in the pull relief
and reassemble the unit.
Power supply line
Check all electrical plug and
terminal connections for
tight and permanent seating,
retighten, if necessary.
NOTE
Electrical wiring
schematic
ATY 260 / ATY 350
Exterior section Interior unit Power supply line
Fan motor
230 V~,
50 Hz,
L1 / N
/ PE
Control conductor
Compressor guard
1N
2
3
B
A
C
4
PE
D
PE
Control conductor
Control conductor
Ground
Reverse valve
Neutral conductor
External
conductor
N
L1 L
1N
PE PE
Grounding
conductor
25