REMKO ATY 260 - Manual (Page 15)

Cleaning of condensation
pump (optional equipment)
An optional integrated or separate
condensation pump may be on the
interior unit, which pumps out any
accumulated condensation into
higher positioned drains.
Observe the care and maintenance
instructions in the separate
Operating instructions.
Type of work
Check / maintenance / inspection
Start up Monthly Semiannually Annually
General
• •
Check voltage and current
• •
Check function of compressor
• •
Check function of fan
• •
Contamination of evaporator fins • •
Check refrigerant quantity
• •
Check condensation discharge
• •
Check insulation • •
Check movable parts
• •
2 Open front cover
6 Clean with lukewarm water
2. Open the lower display cover
on the front side of the unit
by pressing both latches
and carefully fold the cover
downward and remove it from
the bracket (Fig. 3).
3. Push the clips on the filter up
and pull it out on the clips
(Fig. 4)
.
4. Clean the filter with a
commercially available vacuum
cleaner. To do so, turn the dirty
side upward (Fig. 5).
5. Carefully clean off any dirt in
lukewarm water and with mild
cleaner. To do so, turn the dirty
side downward (Fig. 6).
6. When using water, allow the
filter to air dry completely
before reinsertion into the unit.
7. Carefully reinsert the filter.
Make sure it is seated correctly.
8. Close the display cover in
reverse order as described
above.
9. Set the desired operating mode.
4 Pull out the filter
5 Clean with a vacuum cleaner 3 Remove the display cover
15