QuickLabel NiceWatch - Manual (Page 83)

Automating the Software
83
NiceWatch User Guide
SETDATABASE
SETDATABASE =
database_name The name of the currently used database as defined in the
program.
value The name of the new table that should be used as data source.
This command allows you to use some other database with the label file and not the one,
that was connected to the label file at design time.
This other database will only be used when printing labels, the label file will remain
intact with connection to the original database.
SETPRINTPARAM
SETPRINTPARAM paramname=value
This command allows you to set advanced print parameters before printing.
Currently supported PARAMNAMES are:
PAPERBIN Use it to specify from which tray the paper should be used. If
the printer is equipped with more than just one paper / label
tray, you can control which is used for printing.
The name of the tray should be acquired from the printer
driver.
PRINTSPEED Use this parameter so specify printing speed. The value for
parameter varies from one printer to the other. Consult
printer's manuals for numbers.
PRINTDARKNESS Use this parameter so specify printing darkness / contrast.
The value for parameter varies from one printer to the other.
Consult printer's manuals for numbers.
SETTABLE
SETTABLE =
table_name
The name of the currently used table as defined in the program.
value
The name of the new table that should be used as data source.