Pacific Research Solutions RI-1 - Manual (Page 52)

Pacific Research Solutions RI-1 and PE-1 User Manual
Page 46
SYNTAX: 62 [Command number] [Command type] [Group] [Macro start line] [Command name]
STORAGE: EEPROM
PARAMETERS: Command number 01 – 26
Command type 0 = None or Null Command, 1 = Standard, 2 = User S-Commands, 3 = Wildcard
Groups: 0 – 1. Each command is also assigned a group number. You can use S-Command 15
to turn on or off each or all groups of User Commands. See section 12 for more
information on programming macros
Start line: 000 – 255
Command name 1 to 5 characters.
DEFAULT: See default table below
EXAMPLE: 62 15 1 0 040 123 (Standard command number 15 is included in command group 0, points macro start
line 40 and the name is “123”)
62 25 2 1 005 33 (User system command 25 is included in command group 1, points to S-Command
05 and the name is “33”. S-Command 05 is force PTT on for set time, “3315” will
force the PTT on for 1.5 seconds)
62 13 3 1 130 8872 (Wild card command number 13 is included in command group 1, points to macro
start line 130 and the name is “8872”)
DEFAULT USER COMMANDS
Command
Number
Command
Type
Group
Number
Macro
Start Line
Command
Name
Notes
01 Standard 0 001 #1 Repeat mode Off
02 Standard 0 003 *1 Repeat mode NSQ (COS)
03 Standard 0 005 *2 Repeat mode NSQ (COS) and TSQ (CTCSS)
04 Standard 0 007 #0 Link Off
05 Standard 0 009 *0 Link On
06 Standard 0 011 #6 PTT Delay off
07 Standard 0 013 *6 PTT Delay on