Pacific Research Solutions RI-1 - Manual (Page 38)

Pacific Research Solutions RI-1 and PE-1 User Manual
Page 32
S-Cmd 06 SUPRESS FUNCTION ACKNOLODGMENT
This command is typically only used in macros and will suppress or enable the controller function acknowledgment for one
time only. After a user command, the function acknowledgment is automatically played, unless a custom message in embedded
in the command. Also, if an input or message event is detected, the controller will automatically suppress the function
acknowledgment. This command can be used to suppress or force a functions acknowledgment outside the controller’s normal
operation.
SYNTAX:
06 [Mode]
STORAGE: RAM
PARAMETERS: Mode 0 = Clear or force a function suppression one time only.
Mode 1 = Suppress function acknowledgment one time only.
DEFAULT: NA, User commands are not suppressed and all events are suppressed.
EXAMPLE: 06 1 Suppress function acknowledgment one time only
S-Cmd 07 ID INTERVAL TIMER
This command selects the time interval between instances of the CW ID (station identification). The ID will try to be courteous
in that it will wait for the user to un-key before the controller sends the ID. A final station ID will also occur after the repeater
activity has stopped and the timer has elapsed.
SYNTAX:
07 [Time]
READ BACK: 07
STORAGE: RAM/EEPROM
PARAMETERS: Time 0 = Disable ID, 1 to 255 = tenths of minutes (1/10 Minutes or 6 second increments)
DEFAULT: 100 (10.0 Minutes)
EXAMPLE: 07 55 Set 5.5 Minutes between IDs
S-Cmd 08 COURTESY MESSAGE TIMER
The courtesy message timer is the selected time between the end of COS (carrier dropping), to the start of a courtesy message.
This applies to ALL types of courtesy messages. If the carrier is
picked up prior to the courtesy timer expiration, the courtesy
message will be skipped. When the courtesy message is started, the
repeater time-out timer is reset.
SYNTAX:
08 [Time]
STORAGE: RAM/EEPROM
PARAMETERS: Time 0 = Disable Courtesy,
1 to 99 = tenths of seconds (1/10 Seconds)
DEFAULT: 15 (1.5 Seconds)
EXAMPLE: 08 35 3.5 Seconds
S-Cmd 09 RESERVED
RX Active
PTT Output
PTT Delay
S-Cmd 04
Courtesy Delay
S-Cmd 08
Courtesy Msg
S-Cmd 32 1
PTT Timeout
S-Cmd 10
Reset PTT Timeout Timer