Pacific Research Solutions RI-1 - Manual (Page 42)

Pacific Research Solutions RI-1 and PE-1 User Manual
Page 36
S-Cmd 24 REMOTE BASE FREQUENCY SET
This command is used to set the frequency for both transmit and receive frequency in of a synthesized radio that is connected to
the controller.
SYNTAX: 24 [TX/RX] [Frequency]
STORAGE: RAM/EEPROM (This value is not pushed onto the stack and will not reset during initialization)
PARAMETERS: TX/RX 1 = Transmit frequency, 2 = Receive frequency
Frequency = Up to 8 digits, First digit of frequency is the 100s MHz digit and trailing zeros are not
required. Upper and Lower frequency limits set by S-Command 93
Offset (Optional for RX) #1 = Minus, #2 = Simplex, #3 = Plus
DEFAULT: N/A
EXAMPLE: 24 1 45445 Set the transmit frequency to 454.450 MHz
24 2 45945 Set the receive frequency to 459.450 MHz
S-Cmd 25 REMOTE BASE TSQ SELECT
To be added in the near future.
S-Cmd 26 REMOTE BASE TSQ MODE
To be added in the near future.
S-Cmd 27 REMOTE BASE TX POWER SELECT
To be added in the near future.
S-Cmd 28 REMOTE BASE SQUELCH ADJUST
To be added in the near future.
S-Cmd 29 REMOTE BASE VOLUME CONTROL
To be added in the near future.
S-Cmd 30 REMOTE BASE CUSTOM FUNCTION SET
To be added in the near future.