OpenEye CM-512 Installation Manual - Manual (Page 16)

16
RS-485 Switch Setting
Switch SW1
RS-485 Setting
SW2
SW3 Termination
SW4 Line Lock
SW5 System Initialization
SW6 Reserved
RS-485 is the interface that the dome
camera uses to communicate with its
control device; for this reason, the RS-
485 setup of the dome and the control
device must be the same. The RS-485
default setting is half-duplex (see the
diagram right). Do not change the
default setting without a qualified
specialist or supplier’s notice.
Camera ID Setting
Assign an ID number to your camera if there is more than one camera in the
network. The camera ID is set up using the camera ID switch on the back plate of
the camera.
For switch configuration details, please refer to Appendix B in the User Manual.
Note No two cameras should have the same ID, or communication conflict may occur.
RS-485 Setting
Half-duplex Full -duplex