ONICON F-4000 Series User Manual

Page 14

11451 Belcher Road South, Largo, FL 33773 • USA • Tel +1 (727) 447-6140 • Fax +1 (727) 442-5699 • [email protected]

F-4000 Series Ultrasonic Flow Meter Manual 05/15 - 0707-13 / 18838

Page 14

3. Install the mounting straps as shown below. For larger pipes, use multiple straps

connected end-to-end to increase the length of each strap. Leave enough slack in the

straps to allow the assembly to be correctly positioned on the pipe.

4. Move the hardware assembly to its final position on the pipe. Align the brackets

with the prepared surface for each transducer as shown below, ensuring that the

entire assembly is properly oriented along the axis of the pipe. Tighten the assembly

firmly on the pipe. Do not over tighten the straps.

3.3.4 Reflect Mode Mounting Using Track Mount Hardware

1. Prepare the pipe surface as described in section 3.3.2.
2. Place the track mount hardware assembly at the 10:00 or 2:00 position on the pipe at

the desired mounting location. Ensure that it is a clean, smooth area without any raised

spots or seams.

TRACK 400

Prepared Surfaces

Wrap the first mounting strap

around the pipe and under the

spring clip on top of the mounting

bracket. Make sure to position

it so there is easy access to the

adjustment screw. Repeat this

procedure for the second mounting

bracket.

Spring clip

Adjustment screw

Spring clip