Nortec Remote Interface - Manual (Page 22)

18 | Web Interface
Networking Page
The networking page presents parameters that relate to addressing and communication. There
are 5 main categories: IP Address, BMS Timeout, BACnet, Modbus and Nortec Online. A table
describing the parameters and values is outlined below.
Table 8: IP Address Parameters
IP Address Parameter Description
Addressing mode / IP
type Sets the Addressing method of the humidifier. DHCP = Automatically acquire
network address settings, Fixed = manually configure network address and
settings. (Default = DHCP).
Subnet mask Network configuration parameters for the humidifier. Should only be
configured if IP Type = Fixed. Contact your network administrator for further
assistance.
Primary DNS Network configuration parameters for the humidifier. Should only be
configured if IP Type = Fixed. Contact your network administrator for further
assistance.
IP Address The IP address of the humidifier. Should only be configured if IP Type =
Fixed.
Default Gateway Network configuration parameters for the humidifier. Should only be
configured if IP Type = Fixed. Contact your network administrator for further
assistance.
Secondary DNS Network configuration parameters for the humidifier. Should only be
configured if IP Type = Fixed. Contact your network administrator for further
assistance.
Table 9: BMS Timeout Parameters
BMS Timeout
Parameter Description
BMS timeout Sets a maximum time the humidifier will wait with no communication from the
Modbus network before a Modbus timeout warning is generated. Exceeding the
timeout also stops humidifier operation if the humidifier Source is set to Modbus in
the Controls Menu. (Default = 300s).