Nortec Remote Interface - Manual (Page 16)

12 | Web Interface
Status Page
The Status page presents a basic overview of the humidifier. All information is read-only on this
screen. If equipped with a Dual cylinder humidifier (NH-EL 150 and 200 models only) two sets
of parameters, Cylinder A and Cylinder B will be displayed.
Table 2: IP Parameter Descriptions
Parameter Description
Output Displays the instantaneous humidifier output in lbs/hr
Date installed Displays the date at which the humidifier was initially powered
Status
Displays the current status of the humidifier humidifying, Idle, Fault, Service
required.
Weighted hours
Displays the weighted hours. The weighted hours is calculated based on
percentage of the output of the unit. Example: If the unit operates for 2 hours at
50% output, the resulting weighted hour is 1 hour.
Operating hours Displays the total operation hours
Security loop Indicates if the security loop is opened or closed
Channel 1 Displays the channel 1 value (demand or transducer)
Channel 2 Displays the channel 2 value if programmed (demand or transducer)
Blower pack Displays if the Security loop for the blower pack is open or closed.
Channel 1 set point
Displays the set point for channel 1. (irrelevant when control signal is set for
Demand mode)
Channel 2 set point
Displays the set point for channel 2. (irrelevant when control signal is set for
Demand mode)