Nortec HumDigital - Manual (Page 9)

Created: 04.06.2007
9
Changed: 21.12.2007
Printed: 02.03.2009
The advanced status display (STAT) or the settings (SETT) for the selected
zone can be selected using the softkeys below the display.
2.1.2 Status menu (STAT)
The status menu shows the status in detail. As well as the relative humidity,
temperature and the status there is also additional information on the zone.
This shows whether the zone is ready for operation (zone ready) or which
problem has occurred in case of malfunction.
Parameter
Name Function Notes
Hum: Current humidity [% RH], sensor resolution 0.1 %
RH
Temp: current temperature [°C] or [°F], resolution 0.1 °C
Stat: Summary of status
Info: Additional status information
Status
Display Priority* Description
ERR 1 Error
Hand 2 Manual operation on
Humid 3 Humidification active
FWA 4 AFWS active
H req 5 Humidification request
AFWS req 6 AFWS request
Stdby 7 Standby (e.g. target value reached)
* When two status reports occur at once, that with lower priority is shown.
Info
Display Priority* Description
Com err 1 Communication error with HumiPur
Cap err 2 Capability error: HumiPur cannot fulfil the function required.
Causes: Firmware not updated, device technology outdated
no HPS 3 No HPS entered.
Sens err 4 Communication with sensor disturbed (e.g. sensor malfunction)
Max err 5 Maximum hygrostat released
HPS err 6 HPS not released (timeout)
Unkn err 7 Unknown error
Zone Ready 8 Zone ready for operation
* When two status reports occur at once, that with lower priority is shown.