Nortec HumDigital - Manual (Page 14)

Created: 04.06.2007
14
Changed: 21.12.2007
Printed: 02.03.2009
Parameters for CSF3200 (PER)
Name Function Notes
Dtype: Device type CSF3200 (M261,M262, M263,
D250)
DNum: Device number (D251,D252)
Con: Conductivity µ S (D240)
Press: Pump pressure bar (D239)
Flow rate: Flow rate L/h (D238)
Stat: Summary of status See table below
Info: Additional status information See table below
Status of CSF3200 (PER)
Display Priority* Description
ERR 1 Error (M200, M201, M204, M236, M237, M253), com error
Full 2 Tank full (M239)
ON 3 In operation
* When two status reports occur at once, that with lower priority is shown.
Info on CSF3200 (PER)
Display Priority* Description
Com err 1 Communication error
Cap err M 2 Capability error: CenterPur cannot fulfil the function required.
Causes: Firmware not updated, device technology outdated
Cap err D 3 Capability error: PER cannot fulfil the function required.
Causes: Firmware not updated, device technology outdated
Safety press. err 7 Safety pressure error (M201)
Inlet press. err 8 Inlet pressure error (M200)
Conductivity err 3 Conductivity error (M236)
Motor prot. err 6 Motor protection error (M253)
Pump press. err 5 Pump pressure error (M237)
Mntc pump 9 Pump maintenance (M204)
PerPur ready 10 PER ready for operation
* When two status reports occur at once, that with lower priority is shown.
Parameters for LS3400 (SYN)
Name Function Notes
Dtype: Device type LS3400 (M261,M262, M263,
D250)
DNum: Device number (D251,D252)
Con: Conductivity µS (D248)
Stat: Summary of status See table below
Info: Additional status information See table below