NavCom RT-3010 Rev.E - Manual (Page 31)

RT-3010 User Guide - Rev. E
Chapter 4 Configuration
The RT-3010 GPS sensor has a rich interface and
detailed control language, which allows each unit to
be tailored specifically to the required application.
Factory Default Settings
COM1
Configuration - Data port
Rate – 19.2Kbps
Output of NMEA messages GGA & VTG
scheduled @ 1Hz rate
COM2
Configuration - Control Port
Rate – 19.2Kbps
Input/output of Navcom Proprietary messages
used for Navigation and receiver setup. Table 7
describes the default messages that provide the
user the best opportunity to initiate surveying
with minimal effort.
The user has full control over the types of messages
utilized and their associated rates by using either
Navcom Technologies StarUtil or a third party
software/Utility.
4-29