Montigo H34DF - Manual (Page 27)

H*34DF Indoor Gas Fireplace
Page 27 XG0146 - 150204
Installation
Section 9: Installing the Accessories
Top Left Log
Fireplace Base
Notch
Top Right Log
Top Right Log
Fireplace Base
Rear / Bottom Log
Notch in Log
Log stand
Log stand
Figure 28a. H34DF*'s Fireplace Base.
Figure 28b. Bottom/Rear log placement.
Figure 28d. Top Left log placement.
Step 4. Place the top left log as shown in figure 28d. A flat area is
provided on the front left log, and a notch in the Rear bottom
log, as shown in figure 28c. Install the glass door. If the flame
does not appear satisfactory, double-check the air inlet and
exhaust outlet pipe to ensure that they are unobstructed.
Figure 28c. Front base logs placement.
Step 2. Install Bottom Rear log as shown in Figure 28b.
Step 5. Place the top right log as shown in figure 28e. A notch is provided
on the front right log, and a impression in the Rear bottom log.
Figure 28f. Placing Embers.
If logs are not placed properly, excessive sooting will result.
NOTICE Step 7. Place the Embers as shown in figure 28f. Arrange the ember chips
on top of the burner tray. Care should be taken when placing the
embers, as blocked burner ports may cause an incorrect flame
pattern, carbon deposits and delayed ignition. Also, the embers
must NEVER be placed in a way that obstructs any of the air inlet
ports, located at the rear of the burner, as shown in figure 28a.
Pilot Assembly
Fireplace Base
Air Inlets
Installing the H34DF* Log Set (Part # LGSH34)
Installing the Logs:
The H34DF* fireplace is supplied with five ceramic fibre logs. Unpack
the logs and handle them very carefully.
Step 1. Remove the glass door as described in the previous instruction.
Fireplace Base
Front Left
Base Log
Front Right
Base Log
Notch
Notch
Step 3. Install Both front base logs, (Figure 28c) on the log stands
provided. See Figure 28b.
Embers
Embers
Embers
Figure 28e. Top right log placement.
Step 6. Start the fireplace. If the flame appears satisfactory, replace
the glass door. If the flame does not appear satisfactory,
double-check the air inlet and exhaust outlet pipe to ensure
that they are unobstructed.