Montigo H34DF - Manual (Page 25)

H*34DF Indoor Gas Fireplace
Page 25 XG0146 - 150204
Installation
Section 8: Installing & Removing the Door
Removing the door:
The H*34DF* doors are removed in a few simple steps. Follow these
instructions below to remove the Horizontal access panel, unlatch the
door buckles and, remove the door. Replace in reverse order.
Remove the Horizontal Access Panel:
Figure 27a. Locate the door buckles.
Figure 27. Removing and installing the Horizontal Access Panel
Locate the Door Buckles: Step 2:
Step 1:
Remove the Horizontal cover
by placing fingers in both finger
holes, then pushing away from
you and lifting out. Place it
aside during maintenance or
cleaning.
Install in reverse order.
Remove the Horizontal Access Panel:
2
Step 5:
Ensure the tool is firmly
in the lower end of the
slot, (as shown), Then pull
toward you (Caution: hold
the tool securely).
3
Step 6:
Pull hard if necessary to
release the spring ten-
sion. (Caution: The latch
springs back with force,
hold the tool securely).
4
Step 7:
Remove the tool from
the latch slot. Ensure the
latches are hanging freely,
the hook end is released
from the bottom of the door.
(Repeat all 4-steps for the
remaining latches).
Figure 27d.
Figure 27e.
Figure 27f.
Door Latch Hook
Door Latch Slot Hand-hold
Release the Door Buckles
Figure 27b. Door buckle Tool
1
Step 4:
Firmly grasp hand-hold
end of Door buckle tool
and place the machined
end in the slot under door
frame. (as shown)
Figure 27c.
Step 3:
Finger Holes
Installed Gas
Valve Cover
WARNING
When reinstalling door(s), always make sure all door
buckles are properly hooked and fully engaged.