MMD Equipment 185S-6C2 - Manual (Page 35)

5.Periodic Inspection/Maintenance
5-2
TR0049

Be sure to use recommended fuel, oil, grease, and antifreeze.

Do not disassemble or adjust engine, compressor or part(s) for which inspection or maintenance
is not referred to in this manual.

Use genuine parts for replacement.

Any breakdown, caused by using unapproved parts or by wrong handling, will be out of the scope
of “WARRANTY”.

Keep the electrical components away from water or steam.

Waste from machines contains harmful material. Do not dispose of such harmful fluids to the
ground, rivers, lakes or ponds, and sea. It contaminates the environment.

When draining waste fluid from machines, use leakproof containers to hold such fluids from
machine.

Be sure to follow the designated regulations when disposing of oil, fuel, coolant, filters, battery
and other harmful things.
5.2 Daily Inspection and Operation Log
 Be sure to carry out daily inspection every morning before operation. See Chapter 4 “Operation”
of the manual for the details of inspection.
 Pay attention to and carefully observe the following points during daily operation or inspection
and maintenance work. If any trouble or abnormality is found, immediately investigate its cause
and make repairs. If the cause is unknown or not traceable, or if the trouble involves a part or
component not described in the manual, ask your nearest dealer for information.
(a)Controls and instruments function properly.
(b)Quantity and any leak of water, fuel, and oil or any
contamination should be checked.
(c)Appearance, abnormal noise or excessive heat should be
checked.
(d)Loose bolt or nut should be checked.
(e) Any damage, wear or shortage of machine components and parts
should be checked.
(f)Performance of each part or component should be proper.
 Keep the operation log to record constant inspection of each component, so that trouble of the unit
can be easily discovered and preventive measures can be taken.
It is very useful to record information such as discharge pressure, oil level, as well as running hour,
maintenance items and replenishment of lubricant on a daily maintenance log.
Directions: Prohibition of any other jobs or works
than directed herein