MMD Equipment 185S-6C2 - Manual (Page 18)

3. Installation
3-2
3.2 Towing the Unit

When towing unit, make sure there is no person or obstacle at
both front and rear sides and under the unit.

Although the machine is designed to be drawn, drawing is
allowed only in construction site.

Towing speed should be within 12.4mile/h.

When drawing the compressor, make sure to retract the castor.
Drawing the compressor with the castor not retracted, and
drawing it using the castor can lead to serious accidents or
damaged to the castor.

Be sure to use a vehicle with enough capacity to tow the unit in operating weight.

Standard pressure for a tire is at 65psi (4.5bar).

Be sure not to use wrong size or type of tire in changing.

Make sure that the end of the drawbar is so surely and firmly connected to the coupler of the towing
vehicle that the disconnection may not occur while the unit is being towed.

Make sure if there is no deform or damage on the drawing vehicle and the drawbar of the unit.

Be sure to keep your hand or finger away from any part of the coupling device when coupling or
uncoupling a drawing device to a draw bar.

Be sure to drive the drawing vehicle safely, avoiding dangerous place or ground, if any.

If you do not follow the above instructions, it could cause serious injury or big damage.
Caution for towing unit
H000045