MK Products CobraMig 260 PS/Feeder - Manual (Page 35)

CobraMig 260 Owner's Manual - Page 29
FLOW CHART
PROBLEM AREA
JUMPER ON POWER SUPPLY CONTROL BOARD (PSCB) IN WRONG POSITION
REMOTE PENDANT IS DEFECTIVE
SYMPTOM
NO WELD OUTPUT, REMOTE VOLTAGE POT INSTALLED
NOTE :
WHEN THE REMOTE VOLTAGE POT KIT IS INSTALLED AND THE JUMPER
IS IN THE REMOTE POSITION, YOU MAY ONLY USE THE REMOTE POT,
THE FRONT PANEL VOLTAGE POT IS DISABLED UNTIL YOU MOVE THE
JUMPER BACK TO FRONT PANEL POSITION.
10 10
PENDANT
SET JUMPER ON BACK OF WELD
VOLTAGE CONTROL PANEL TO THE
REMOTE POSITION AND CHECK THAT
THE PENDANT IS PLUGGED INTO THE
FRONT PANEL CONNECTOR
IS REMOTE VOLTAGE
PENDANT WORKING NOW ?
IS FRONT PANEL VOLTAGE
KNOB WORKING NOW ?
NO
GO TO FLOW CHART #7
NO YES
GO TO TO FLOW CHART #7
READY TO WELD READY TO WELD
YES YES
SET JUMPER ON BACK OF WELD
VOLTAGE CONTROL PANEL TO THE
PANEL POSITION
NO
PANEL
DO YOU WANT TO USE PENDANT OR FRONT
PANEL VOLTAGE CONTROL KNOB
IS REMOTE VOLTAGE KIT
(005-0584) INSTALLED ?
START