Microsens MS400900M - Manual (Page 21)

24-Port PoE Injector User’s Manual Page 19/40
System IP Configuration
User can configure the IP Settings and DHCP client function in this section.
DHCP Client: Enable or disable the DHCP client function. When DHCP client
function is enabled, the PoE injector will be assigned the IP address from the
network DHCP server. The default IP address will be replaced by the IP address
which is assigned by DHCP server. After user click Apply button, a popup
dialog shows up. It is to inform the user that when the DHCP client is enabled,
the current IP will lose and user should get the new IP on the DHCP server.
IP Address: Assign the IP address that the network is using. If DHCP client
function is enabled, and then user needn’t assign the IP address manually.
Instead, the network DHCP server will assign the IP address for the PoE injector
and display it in this column. The default IP is 192.168.16.1
Subnet Mask: Assign the subnet mask of the IP address. If DHCP client
function is enabled, and then user needn’t assign the subnet mask
Gateway: Assign the network gateway for the PoE injector. The default
gateway is 192.168.16.254
System IP Configure interface
MICROSENS GmbH & Co. KG · Kueferstraße 16 · 59067 Hamm / Germany · Tel. +49 23 81/94 52-0 · FAX -100 · www.microsens.com