Microsens MS400900M - Manual (Page 15)

24-Port PoE Injector User’s Manual Page 13/40
Login in the Console Interface
When the connection between Injector and PC is ready, turn on the PC and run a
terminal emulation program or Hyper Terminal and configure its
communication parameters to match the following default characteristics of
the console port:
Baud Rate: 9600 bps
Data Bits: 8
Parity: none
Stop Bit: 1
Flow control: None
The settings of communication parameters
After finishing the parameter settings, click “OK“. When the blank screen shows
up, press Enter key to bring out the login prompt. Type the default User Name
“admin“ and default Password “microsens“, then press Enter key and the
command line interface of console management appears. Please see below figure
for login screen.
MICROSENS GmbH & Co. KG · Kueferstraße 16 · 59067 Hamm / Germany · Tel. +49 23 81/94 52-0 · FAX -100 · www.microsens.com