MicroE CET for MTE Series - Manual (Page 22)

Page 22
CET™ Scale, MTE Side Mount Configuration
Installation By Mounted Applicator Tool
7.
Insert a short section of tape scale into the tool, approximately 50mm (2 inches).
Insert the first short section of tape scale so that it emerges just past the plunger knob to a desired end
location. Press down on this exposed 3-5mm section of tape.
Plunger in the UP position Press down on this
small section of tape
8.
Rotate the pressure plunger knob to the “Down” position.
Rotate the plunger knob so that the key-way notch is in the position shown.
Plunger knob in the
DOWN position
Close-up of plunger knob in the
DOWN position. Position of notch
indicates that the plunger is in the
DOWN position.