MicroE CET for MTE Series - Manual (Page 13)

Page 13
Applicator tool spring loaded contact
cylinder Up/Down position knob
CET scale entry
channel
Spring loaded
contact cylinder
1.
Overview of CET Scale Applicator Tool (Model Number: TSAT-CET)
The CET Scale Applicator Tool
mounts into the MTE’s sensor
mounting holes.
The orientation of the CET Applicator Tool
corresponds to the MTE encoder as shown below.
The benching surfaces correspond to the B and C
faces shown in the MTE interface drawing.
B
B
C
C
2.
Applicator Tool benching faces
Shown below is the MTE Sensor head mounted in
its fixture.
3.
Applicator Tool - mounting
The CET Applicator Tool mounted in the same
MTE Sensor fixture, ready for CET Scale
installation.
CET™ Scale, MTE Top Mount Configuration
Installation By Mounted Applicator Tool
NOTE:
For best system performance, talc-free gloves or finger cots should be worn during all
steps of tape scale installation.
Thoroughly clean the scale mounting surface and reference edge using a cotton swab or
lint-free cloth dampened with isopropyl alcohol or acetone. Remove all dust and particles.
Tool orientation
arrows