MicroE CET for MTE Series - Manual (Page 10)

Page 10
CET™ Scale, MTE Top/Side Mount Configurations
Installation By Hand
4.
Place the CET™ Tape Scale against the mounting surface “D” reference edge.
Place the 25mm (1 inch) exposed adhesive end of the tape scale against the mounting surface “D” reference
edge as shown and press firmly on the end.
NOTE:
Adhesive exposed by removing the adhesive bottom liner can touch the mounting
surface only once.
3.
Flip the tape over with the 25mm (1 inch) exposed adhesive surface facing down. Be sure not to touch or
contaminate the exposed adhesive surface. Be sure the orientation arrows on the blue protective film point to
the “D” reference edge.
“D” reference edge as shown in the
MTE interface drawing. Tape scale orientation arrows.