MicroE CET for MTE Series - Manual (Page 16)

Page 16
CET™ Scale, MTE Top Mount Configuration
Installation By Mounted Applicator Tool
9.
Tape Scale Insertion
Push the scale slowly into the Applicator Tool until the tape scale emerges from the side of the mounting fixture
to a desired end location. Press down on this exposed 3-5mm section of tape.
10.
Rotate Contact Cylinder Knob to Down
Turn the applicator tool contact cylinder knob to the
DOWN position.
Turning the knob to the
DOWN position, applies firm pressure to the tape scale under the applicator tool. This
action presses the adhesive side of the tape scale firmly onto the scale mounting surface.
Press down on end of tape.
Tool contact cylinder in DOWN position