Microcom 412 - Manual (Page 101)

Appendix D Quick Reference Command Summary
412 Operators Manual 93
80 Clears Commands 86, 88, 89.
81 Disable Serial Number Function: Will disable either single or multiple serial
number commands.
XX 84 Load Text String Number to increment/decrement: Tells the printer which text
string number to increment or decrement. For single serial numbers. Section
5.3.8.
XX 85 Load increment/decrement step value: This is the value that the single serial
number is incremented or decremented.
86 Single Serial Number Status:
0 Disable increment and decrement.
1 Enable increment. The serial number will be decreased by the value from ^D85.
2 Enable decrement. The serial number will be decreased by the value from ^D85.
XX 87 Load Field Number to Clear Increment/Decrement
status: Clear the status of one or more serial numbers with this command.
XX 88 Load Field Number to Increment by 1: For multiple serial numbers.
XX 89 Load Field Number to Decrement by 1: For multiple serial numbers.
XX 91 Gap Detection Sensitivity: The proper value may be obtained using the auto-
size (^D39) command. The ^A value sets the point (0-255) at which the printer
detects a gap or black mark. This command is non-volatile and will default to 30
when using the transmissive sensor and 120 when using the reflective sensor.
Although this default value should work properly with most media, it is a good
idea to place this command at the beginning of all format files in order to
guarantee that it has not been changed by another user or application. If this
value is not correct, the printer may not detect the end of the label and may feed
extra media or stop too soon.
XX 92 Load Value for Slices to Process: This command adjusts the number of slices
generated before the drive motor starts moving. The default is 256 and the valid
range is 1 to 366.
93 Load Control Code Recognition Status:
0 Enable control code recognition.
1 Disable control code recognition.
XX 95 Load User Defined Steps for Label to Advance:
XX 96 Load Advance Delay: ^A specifies how many milliseconds to delay
repositioning of the label in tag/tear and peel-and-dispense modes.
97 Tag/Tear Operation:
0 Turns off tag/tear operation.
1 Advance after every label.
2 Advance after copies count.