Meinberg VP100 20NET - Manual (Page 5)

VP100/20NET Page 5 of 25
2. MOUNTING AND CONNECTION OF VP100/20NET
2.1 Mounting
The regular, single-type display VP100/20 NET is adapted for the wall mounting. For this purpose,
two right-angled carriers, with screws and wall plugs are enclosed in the package. The double-type
display is designed for the ceiling mounting.
Fig. 2: Wall mounting, all dimensions in mm.
2.2 Connection and operation of the display
Connect VP100/20 NET to the mains. As it has no "power-on" switch, it will start functioning
immediately. You must also connect the device to the Ethernet network. The connector for the
Ethernet connection is installed at the rear of the enclosure
. It is labeled “Network”. The time is
displayed following the introductory text. If after the device's last turning-off the internal memory-
supporting battery has been discharged, all messages stored in the display will be deleted.
Immediately after the device has been switched on, a dot is displayed between the date and the
hour, which means that the display has not yet been synchronized with the NTP server's time. Using