Meinberg VP100 20NET - Manual (Page 21)

VP100/20NET Page 21 of 25
A stratum between 1 and 15 can be assigned to each display. The stratum of a NTP server should
be lower than the display’s stratum, otherwise the synchronization can not be established. By clicking
»Send settings« the settings are sent to the display.
In the submenu »Display info« the display's type, software version and MAC address of the network
interface are listed.
By clicking on »Display settings« the following display settings are being provided: Brightness,
Language, Daylight Saving and Time Zone.
By clicking on »Send settings«the settings are sent to the display. By clicking »Refresh settings« the
current settings are being listed.
Exit
This command is used to close the program. All the settings and messages remain on the hard disk,
and are used on the occasion of the next starting of the program.