Measurement Computing PointScan 100 Series rev.1.0 - Manual (Page 7)

PointScan/100 User’s Manual 9-12-01 General Information 1-1
General Information 1
Overview
This manual will help you install and maintain PointScan/100 I/O modules. In summary, wiring for power,
communications and I/O is connected to each module’s base. Then, setup choices are entered using the
IO Toolkit software and the system will be ready to run. Shown below are some typical system
configurations using PointScan/100 I/O:
Using Ethernet based PointScan/100 I/O with (RS485) PointScan/200 expansion I/O
General Specifications
These general specifications apply to all PointScan/100 I/O modules. More detailed product specifications
may be found in the online help system of the IO Toolkit configuration software.
Supply Voltage 10 - 30 VDC, 1.2 Watt typical per module
(48 mA @ 24 VDC – varies by module and load).
RS485 Expansion Connect up to 32 PointScan/200 modules or Modbus
devices using RS485
Ethernet Isolation 1200 Volts RMS (for 1 minute)
Operating Temperature -30 to 70 °C
Storage Temperature -40 to 85
°C
Humidity 5 to 95% (non-condensing)