Measurement Computing 2000 Series Daqboar - Manual (Page 75)

DaqBoard/2000 and DaqBoard/2000c User’s Manual 03-01-02 System Connections & Pinouts 2-7
DBK209
The DBK209 is a mini-adapter board suitable for both analog
and digital expansion. The board provides three DB37
connectors (P1, P2, and P3).
DBK209 connects to DaqBoard/2000 Series or /2000c Series
P4 connector via a CA-195 cable.
Other than the form factor, DBK209 is identical to DBK201.
• P1 is used for ANALOG I/O.
• P2 is used for DIGITAL I/O.
• P3 is used for Pulse/Frequency (Digital and
Counter/Timer) I/O.
DBK209’s P4 (100-pin connector) connects to the
DaqBoard/2000 Series or /2000c Series board’s P4
connector via a CA-195 Cable.
DBK209
P4-to-P1/P2/P3 Mini-adapter Board
Pinouts for DaqBoard/2000 Series and /2000c Series Boards
Reference Notes: You must set up DaqView for the particular DBKs in your system. If you
are unfamiliar with the method of setting up DBKs in DaqView, or if you need a refresher,
refer to the following documents as needed.
➣
The DBK Set Up in DaqView chapter of the DBK Option Cards Modules User’s
Manual (p/n 457-0905),
➣
The DBK Option Cards Modules User’s Manual (p/n 457-0905), for the applicable
DBK document module(s). The documentation discusses hardware configuration
aspects that require setup in software.
➣
The DaqView document module.
During software installation, documentation is automatically installed onto your hard drive
as a part of product support. The default location is the Programs directory, which can be
accessed through the Windows Desktop.
Note: As new DBKs become available, be sure to use the latest revision of DaqView with the proper
configuration options.
&$87,21
Do not confuse connectors. Ensure that you only connect P1 I/Os to P1,
P2 I/Os to P2, and P3 I/Os to P3. Improper connection may result in equipment
damage.
The following P1, P2, and P3 connector pinouts pertain to the DBK200 Series adapter boards that were
discussed in the first part of this chapter. P1, P2, and P3 are subset connectors of the 100-pin P4 connector
found on the DaqBoard/2000 Series and /2000c Series boards, and for that reason P4 pin-correlation is
provided.
&$87,21
Do not confuse connectors. Ensure that you only connect P1 I/Os to P1,
P2 I/Os to P2, and P3 I/Os to P3. Improper connection may result in equipment
damage.
Note: In the pinouts that follow, some pins are irrelevant to certain DaqBoards. For example:
DaqBoard/2002, /2002c, /2004, and 2004c have no P1 correlation; and for those boards P1 and the
associated P4 pins should be ignored. The DaqBoard/2003 and /2003c only relate to P3 and the
associated P4 pins; but for these two boards, a DBK205 screw-terminal adapter is typically used
(see page 2-3). Note that chapter 1,
Device Systems and Device Overviews , contains detailed
information that is specific to each board.