Measurement Computing 2000 Series Daqboar User Manual
Page 14
IG-4 DaqBoard/2000 Series Installation Guide
10-17-02
1033-0940, rev 6.0
5. On the PC’s rear panel, loosen and remove the screw for the blank adapter
plate that corresponds with the chosen PCI bus.
6. Remove the adapter plate for the chosen PCI slot.
Refer to your PC Owner’s Manual if needed.
7. Align groove in the DaqBoard/2000 Series board’s PCI edge-connector with
the ridge of the desired PCI slot, and with the PC’s corresponding rear-panel
slot.
8. Push the board firmly into the PCI slot. The board will snap into position.
9. Secure the board by inserting the rear-panel adapter-plate screw.
10. Using the previous steps, install additional boards into available PCI bus-slots,
if applicable to your application.
11. Replace the computer’s cover.
Removing a Blank Adapter Plate
12. Plug in all cords and cables that were removed in step 1.
13. Apply power to, and start up the PC.
Note: At this point some PCs may prompt you to insert an
installation disk. While this is rare, if you do receive such a
prompt simply place the install CD-ROM into the disk drive
and follow additional screen prompts.
Installing a DaqBoard/2000 Series Board