Measurement Computing 2000 Series Daqboar - Manual (Page 69)

DaqBoard/2000 and DaqBoard/2000c User’s Manual 03-01-02 System Connections & Pinouts 2-1
System Connections and Pinouts 2
Overview …… 2-1
DBK200 Series, P4 Connector Options …… 2-2
Pinouts for DaqBoard/2000 Series and /2000c Series Boards …… 2-7
&$87,21
Turn off power to all devices connected to the system before connecting cables or
setting configuration jumpers and switches. Electrical shock or damage to
equipment can result even under low-voltage conditions.
&$87,21
The discharge of static electricity can damage some electronic components.
Semiconductor devices are especially susceptible to ESD damage. You should
always handle components carefully, and you should never touch connector pins or
circuit components unless you are following ESD guidelines in an appropriate ESD
controlled area. Such guidelines include the use of properly grounded mats and
wrist straps, ESD bags and cartons, and related procedures.
Overview
DaqBoard/2000 Series and DaqBoard/2000c Series boards communicate [external from the host PC]
through the board’s 100-pin P4 connector. Typically, a DBK200 Series P4-adapter is used to provide one or
more DB37 connectors (P1, P2, P3), which are subsets of the 100-pin P4 connector.
Pinouts for P1, P2, P3, and P4 are located after the following DBK200 Series board descriptions.
DaqBoard/2000 Series and cPCI DaqBoard/2000c Series boards communicate [external from the host PC]
through the board’s 100-pin P4 connector. Typically a DBK200 Series P4-adapter is used to provide one or
more DB37 connectors (P1, P2, P3).
Using a DBK201 P4-to-P1/P2/P3 Adapter