Measurement Computing DASYLab User Manual - Manual (Page 17)

DASYLab
© National Instruments Ireland Resources Limited | 1-7
5. Repeat these steps to connect the bottom data channel to Input 1 of the
Formula Interpreter.
6. Double-click the Y/t Chart module to open the dialog box.
a.
Click the Plus button next to the channel bar to create a third input.
b. Click OK. DASYLab adds another input to the Y/t Chart.
7. Click Output 0 of the Formula Interpreter and connect this output to
Input 2 of the Y/t Chart.
Tip
To delete a data channel, right-click the data channel twice
with the right mouse button (not a double click).
8. Start a measurement.
The Y/t Chart display window now shows three curves: the sine signal,
the rectangular signal, and the calculated signal.
Figure 1-5. Displaying Generated and Calculated Signals
9. Stop the measurement after some time.