Measurement Computing E-1608 - Manual (Page 6)

6
Chapter 1
Introducing the E-1608
The E-1608 is compatible with both TCP/IP (IPv4 only) and user datagram protocol (UDP) network protocols.
The E-1608 provides the following features:
 Four differential (DIFF) or eight single-ended (SE) analog input channels (16-bit)
 Sample rates up to 250 kS/s aggregate
 Two analog output channels (16-bit)
 Eight individually configurable digital I/O channels
 One counter channel (32-bit) that counts TTL pulses
 Screw terminals for field wiring connections
The E-1608 is powered by a 5 volt power adapter.
Ethernet interface
The E-1608 has one built-in 10/100 BASE-T auto-negotiation, high-speed communication port.
With the Ethernet interface, you can remotely access and configure your E-1608 from anywhere on the network.
Only one computer can control the E-1608 at one time. The networking protocols are TCP/IP and UDP.
A unique media access control (MAC) address is assigned to each device at the factory.
You configure the Ethernet connection settings through software. A network name in the format E-1608-
xxxxxx , is assigned to the E-1608, where xxxxxx represents the lower six characters of the device MAC
address.