Measurement Computing E-1608 - Manual (Page 22)

E-1608 User's Guide Specifications
22
Parameter Condition Specification
Output coupling DC
Power on and
reset state DACs cleared to uncalibrated zero-scale: 0 V, ±50 mV unless the alarm
function is enabled for the output (Note 3)
Alarm functionality
Either or both outputs may be configured to go to defined values when
an Ethernet connection with a host is established or lost.
Output update rate 1000 to 5000 S/s typ, on local network (Note 4)
Slew rate 5 V/µs
Throughput Software paced 1000 to 5000 S/s typ, on local network (Note 4)
Note 2: Leave unused AOUTx output channels disconnected.
Note 3: AOUTx defaults to 0 V whenever the device is powered on or a reset command is issued to the device,
unless the alarm functionality is enabled for the output.
Note 4: This is the typical throughput when the device and host are both connected by Ethernet to the same
local network. The throughput can vary significantly, and typical throughput is not guaranteed if a
wireless connection is involved or data is sent over the internet.
Table 6. Calibrated absolute accuracy specifications
Range Absolute accuracy (±LSB)
±10 V 18.7
Table 7. Calibrated absolute accuracy components specifications
Range % of reading Offset
(±mV) Offset tempco
(µV/°C) Gain tempco
(ppm of range/°C)
±10 V ± 0.024 2.2 30.1 13.2
Table 8. Relative accuracy specifications (±LSB)
Range Relative accuracy (INL)
±10 V 4.0 typ
Analog input/output calibration
Table 9. Analog input/output calibration specifications
Parameter Specification
Recommended warm-up time 15 minutes min
Calibration method Factory
Calibration interval 1 year (factory calibration)
Digital input/output
Table 10. Digital input/output specifications
Parameter Specification
Digital type 5 V TTL input / advanced BiCMOS output
Number of I/O 8
Configuration Independently configured for input or output
Pull-up configuration
All pins pulled up to 5 V using 47 K resistors (default).
Can be changed to pull-down using an internal jumper.
Digital I/O transfer rate
(system-paced) 100 to 5000 port reads/writes or single bit reads/writes per second typ, on local
network (Note 5)
Alarm functionality
Any combination of DIO bits may be configured to become outputs and go to defined
values when an Ethernet connection with a host is established or lost.
Power on and reset state All bits are input unless the alarm functionality is enabled for them.