beautypg.com

Network factory default settings, Network security, Led displays and the factory reset button – Measurement Computing E-1608 User Manual

Page 26: Environmental, Mechanical

background image

E-1608 User's Guide

Specifications

26

Network factory default settings

Table 18. Factory default specifications

Parameter

Specification

Factory default IP address

192.168.0.101

Factory default subnet mask

255.255.255.0

Factory default Gateway

192.168.0.1

Factory default DHCP setting

DHCP + link-local enabled

Network security

Table 19. Factory default specifications

Parameter

Specification

Security implementation

TCP sockets are not opened unless application sends the correct PIN code (stored in
non-volatile memory, may be changed by user, default value 0000)

Number of concurrent sessions

1

Vulnerabilities

TCP Sequence Number Approximation Vulnerability

LED displays and the factory reset button

Table 20. LED and button configurations

Parameter

Specification

Power LED (top)

3.3 V < V

ext

< 5.9 V: On

V

ext

< 3.3 V

,

V

ext

> 5.9 V: Off (power fault)

Activity LED (bottom)

On when there is a valid host connection and blinks when a command is received or
an AInScan is running.

Ethernet connector LEDS

Left (green): Link/activity indicator; on when there is a valid Ethernet link and
blinks when network activity is detected.

Right (yellow): Speed indicator; on for 100 Mbps, off for 10 Mbps or no link.

Factory reset button

Used to reset the network configuration settings to the factory default values.

Press the button when applying power to the device and continue to hold for
4 seconds; the device LEDs stay off, and then both the Power and Activity LEDs
blink once indicating that the settings have been restored to the defaults.

Release the button so the device continues startup with the default settings. If the
button is released before the two LEDs blink, the settings are not affected and the
device starts up normally.

Environmental

Table 21. Environmental specifications

Parameter

Specification

Operating temperature range

0 °C to 55 °C max

Storage temperature range

–40 °C to 85 °C max

Humidity

0% to 90% non-condensing max

Mechanical

Table 22. Mechanical specifications

Parameter

Specification

Dimensions (L × W × H)

117.9 × 82.8 × 29.0 mm (4.64 × 3.26 × 1.14 in.)