beautypg.com

7 aurora routing, Aurora routing – Lynx Studio LynxTWO/Aurora Interface Kit User Manual

Page 8

background image

7 Aurora Routing


After installation, the Aurora will need to be configured to send and receive signals from the
LynxTWO/L22.

Signals from the Aurora analog or digital inputs can be delivered to the LStream inputs of the
LynxTWO/L22, and signals from the LynxTWO/L22s can be routed to the Aurora outputs. In
Section 8 we will look at the Lynx Mixer LStream device assignments and routings.

With the LStream LynxTWO Interface Bracket installed into the Aurora, signals routed to the
Aurora’s LSLOT inputs and outputs will be delivered to and from the LynxTWO/L22.
This routing can be established globally from the Aurora front panel or on a per-channel basis from
the Aurora Remote Control Software. The Aurora Remote Control Software can be used with a PC
or Macintosh computer equipped with a Lynx AES16, MIDI Interface or Infrared transceiver. For
more information, please consult the Aurora Remote Control manual.

With front panel routing all available channels of the input source selected (16 for Aurora 16, 8 for
Aurora 8) will be mapped to directly corresponding Aurora output channels (i.e. In 1 to Out 1, In 2 to
Out 2, etc.). In its default state, the Aurora sends signals routed to its digital outputs to the LSLOT
outputs as well. This means that whatever signal source you want to be delivered to the
LynxTWO/L22 should be routed to the Aurora digital outputs. With the Aurora Remote Control
software this orientation can be changed so that the LSLOT outputs mirror the analog outputs. In
either case, signals will be sent to the LSLOT destination and selected Aurora outputs (analog or
digital) simultaneously. Keep this in mind when configuring your monitoring equipment.

This table illustrates the front panel routing possibilities:
.

To route signals from the LynxTWO/L22 to the Aurora analog

outputs, select “LSLOT IN” as the signal source from the TO

ANALOG OUT selection button.

To route signals from the LynxTWO/L22 to the Aurora digital

outputs, select “LSLOT IN” as the signal source from the TO

DIGITAL OUT selection button.

When routing from the front panel, signals sent to the digital

outputs are sent simultaneously to the LSLOT outputs. To

choose the signal source to be routed to the LynxTWO/L22,

select the appropriate source with the TO DIGITAL OUT

button. Note: When “LSLOT” is chosen here, signals from the

LynxTWO/L22 outputs will be routed back to the

LynxTWO/L22 inputs, in addition to any destinations connected

to the Aurora AES outputs. Also, if “Analog Out” is chosen as

the TO LSLOT OUT choice in the Aurora Remote Control

software, then the TO ANALOG OUT button would be where

the applicable sources would be chosen.


Page 6