Lynx Studio LynxTWO/Aurora Interface Kit - Manual (Page 11)

8.5 LStream Input Routing
The signals from the Aurora are routed into the digital mixer of the host card via the card’s sync port.
This data can be routed to the record bus using the Input Source Select function within each Input
Submixer.
The Input Source Selection buttons on the Record/Play page of the LynxTWO/L22 Mixer provide
access to the input select function. These buttons are located just above the meters for each input
channel.
When these buttons are clicked, a menu containing the 40 possible input
sources will be displayed. To access channels from the Aurora, choose
sources from LStream 1 In 1 through LStream 1 In 16. With an Aurora
8, choose sources from LStream 1 In 1 through LStream 1 In 8.
Each Input Source is routed to either the left or right channel of a record
device. The record device number is located under the meters, e.g.,
Record 1, Record 2. When setting up for recording in an audio editing
application, these device numbers are used to specify the recording
source.
Page 9