Lynx Studio LynxTWO/Aurora Interface Kit - Manual (Page 6)

5. Ground your self to earth ground. Carefully connect the ribbon cable from the back of the
LStream LynxTWO Interface Bracket to the JP3 LStream port on the Aurora mainboard. The
red stripe on the ribbon cable should face the back of the Aurora. The connector is designed
to only fit securely with the correct orientation. Take care to not force the ribbon cable
connector onto the pins.
6.
Connect the cable CBL-LSEXT to the 14-pin D-Sub port on the LStream LynxTWO Interface
Bracket. Tighten thumbscrews until secure.
7.
Connect the other end of the CBL-LSEXT to the sync port on the back of the LynxTWO/L22.
Tighten thumbscrews until secure.
8.
Plug in and power up the Aurora using the front panel standby switch. Set the SYNC
SOURCE to “LSLOT”.
9.
Launch the Lynx Mixer. If necessary save a mixer scene with the mixer in its current state.
Then click Mixer > Restore Defaults. NOTE: In OSX, click File > Restore Defaults.
Page 4