6 installation procedure, Installation procedure – Lynx Studio LynxTWO/Aurora Interface Kit User Manual
Page 5

6 Installation Procedure
1.
Remove the AC power cord. Take the top off of the Aurora 16 or Aurora 8. There are seven
large screws plus one small screw near the center of the front faceplate.
2.
Remove the LSlot Interface Port cover above the AES I/O Ports by removing the two
mounting screws. Set these two screws aside, as they will be used to install the LSLOT
Interface Bracket.
3.
Mount the LStream LynxTWO Interface Bracket in the LSLOT Interface port. Secure with
the two mounting screws which were removed in step 2.
4.
Identify the 14-pin header labeled JP3 on the Aurora mainboard.
Page 3