Lencore Spectra i.Net: Installation and Operations Manual - Manual (Page 20)

section 5
5.3 | hang speakers
1
2
3
4
Climb ladder and access the ceiling plenum
Hang speaker units in plenum area at marked locations using preferred hanging method
(powder action gun such as a Hilti-gun™ or drill and screw; check your local building codes
for allowable hanging methods and standards)
Drive a nail holding the clip with the speaker chain and speaker into ceiling
Pull and connect audio cables to speakers by channel
IMPORTANT
Follow channel designations
on drawings (1,2, 3,…8) so
that proper tuning of the system
can take place. Any changes
to the system MUST be
designated on the drawing
16
* keep speakers installed at very
consistent heights
6"-12"
NOTE: If installing inline speakers, make sure the potentiometer on the bottom of the speaker
is set to the MAXIMUM (clockwise) setting.