Lencore Spectra i.Net: Sound Manager - Manual (Page 31)

and click “Submit Volume/Contour” to immediately send volume changes to
the selected group as shown in Figure 21 below. The group has NOT been
saved at this point.
Figure 21
6. When finished editing and selecting OP/Channels or setting Volume, click the
Floppy Disk symbol in the Groups area to save the group settings as shown
in Figure 22 below.
Figure 22
NOTE: ALL CALL (zone 00) paging volume level is based on the paging volume level set for a particular OP or
OP channel. If no paging volume levels were changed for any OP channel, the default paging volume level
is set to 77dB. All channels on the entire system can have their paging volume raised or lowered by
creating a Temporary Group, adding all OPs/Channels to this group, adjusting the paging volume for this
Group and “Submitting” the change. Once completed, to avoid Group conflict with another Paging Zone,
this Temporary Group must be deleted!
REMINDER: There is NO Contour adjustment for paging, and the Contour section of this
screen has been disabled.
The information contained herein is proprietary to Lencore Acoustics Corp. and copyright protected. No part of this manual can be copied,
used or distributed without prior authorization from Lencore Acoustics Corp. © Copyright 2010 28
V 1.9