Directed Electronics 3000 - Manual (Page 25)

22 © 2 0 0 5 d i re c t e d e l e c t ro n i c s , a l l r i g h t s re s e r v e d
manual programming instructions
It is a good idea to document changes by taking note of all feature
changes made in programming mode.
To enter the User Selectable Features programming:
1. Ignition on - Turn the ignition to the on/run position or start
the engine.
2. Enter PIN - Your PIN code.
FOR EXAMPLE: To enter a PIN code of 4301—
Press four times,
then once. This enters the digit 4.
then three times,
then once. This enters the digit 3
and then once. This enters a 0 as there was
not a previous digit entered with .
then once,
and then once. This enters the final digit 1.
3. Hold/Chirp/Release - After entering the PIN code, press and
hold
until a chirp is heard and the LED turns on, then
release the button. You have now entered the feature selec-
tion position of the User Selectable Features grid.
4. Column select - Press and release the same number of
times as the desired column. After a pause the siren will
chirp the same number of times as the selected column for
confirmation (e.g. 3-chirps means column 3 of the features
is selected).
5. Feature select - Press and release the same number of
times as the desired row. The siren will chirp with each press.
The feature can now be changed using the remote control.