Directed Electronics 3000 - Manual (Page 24)

21 © 2 0 0 5 d i re c t e d e l e c t ro n i c s , a l l r i g h t s re s e r v e d
programming options
Programming options control what your system does during normal
operation, and require few or no additional parts. However, some may
require additional installation labor.
Following is a list of the program settings, with the factory settings in bold:
z Autoarming on or autoarming off of the alarm : Automatic
arming 30-seconds after ignition turned off.
z Arming/disarming confirmation siren chirps off, loud or
quiet. The siren arm/disarm chirps can be either full volume,
6 decibels quieter, or turned off completely.
z Panic mode: on/off.
z Siren duration: 30/60/90 seconds.
z Set PIN code: Allows you to enter your own PIN code, over-
writing the factory PIN code.
z Siren tones: The output of the siren consists of six different
tones in sequence. Any of these tones can be eliminated, result-
ing in a unique, easily identifiable siren sound.
z NPC ® : Nuisance Prevention ® Circuitry on/off. Inhibits false
alarming if a protective zone repetitively alarms.
z Remote Valet: on/off.
z Reset settings to default (except for PIN code)
z New remote learn features: Allows programming individual
transmitter channels to custom configurations. Refer to User
Selectable Features Descriptions - Column Three.
z Clear all Remotes: Removes all remote controls from memory.