Directed Electronics 3000 - Manual (Page 16)

13 © 2 0 0 5 d i re c t e d e l e c t ro n i c s , a l l r i g h t s re s e r v e d
remain on if Valet Mode has been entered.
The LED status indicator will light steadily if you are entering Valet Mode.
To exit Valet Mode:
1. Turn the ignition On.
2. Enter your PIN code as described previously
3. When you enter the last digit the LED will light up, contin-
ue to hold the
button.
4. The system will exit Valet mode and the status LED indicator
will extinguish.
N NO OTTEE:: If One-time Valet is programmed On by your installer, the system will auto-
matically exit Valet mode the next time the ignition is turned on.
remote valet mode
The operations described in this section refer to remote buttons.
Remember, the buttons used in all the instructions in this guide corre-
spond to the Standard Configuration for the 3-button remote. This
may not be how your remote is set up.
To enter Valet Mode, press and simultaneously. The LED
status indicator will illuminate continuously if you are entering Valet
Mode, or will turn off if you are exiting Valet Mode.
N Noottee:: The LED will turn off when the ignition is ON.