Auxiliary channel bypass, Panic mode, Valet mode – Directed Electronics 3000 User Manual

Page 15

auxiliary channel bypass

All alarm sensor inputs will be bypassed while a pulsed or timed auxil-

iary output is active.

panic mode

If you are threatened near your vehicle, you can attract attention by

triggering the system with your remote! Just press

for two sec-

onds to enter Panic Mode. The siren will sound and the indicator lights

will flash for the programmed duration (5-minutes maximum). To stop

Panic Mode at any time press

on the remote again.

valet mode

You can prevent your security system from automatically arming by

using Valet Mode. This is very useful when washing the motorcycle for

example. In Valet Mode, the security system will not arm, even with the

remote, but any accessory functions will continue to work normally.

To enter Valet Mode:

1. Turn the ignition On.

2. Enter the PIN code as described in the Disarming

Without a Remote section.

3. When you enter the last digit continue to hold the

button for at least three seconds then

release. The LED status indicator will light up and