Directed Electronics 3000 - Manual (Page 18)

15 © 2 0 0 5 d i re c t e d e l e c t ro n i c s , a l l r i g h t s re s e r v e d
NPC ® is On/Off programmable. See your dealer and the Programming
section of this guide for more information.
multiple event total recall
This will report the last eight system triggers in reverse chronological
order.
1. Press and hold of the Valet switch.
2. While still holding , arm and disarm the system, then
release the button.
3. The LED will start to flash to indicate the most recent trigger
and proceed down to the eighth trigger. For more informa-
tion, please refer to the Table of Zones section of this guide.
battery back-up siren
The built-in battery back-up siren protects the system if a thief discon-
nects power and/or cuts or tampers with the power supply wires while
the system is armed. If system power is lost the siren will sound for five
minutes and then reset.
nnoottee:: Arming and disarming the system does not reset this function.The
only ways to reset a bypassed zone are for it to not trigger for 60 min-
utes, or to turn on the ignition. If testing your system, it is important to
remember that the NPC
® programming can cause zones to be
bypassed and appear to stop working. If five chirps are heard when
disarming, NPC
® has been engaged. If you wish to clear the NPC ®
memory, turn the ignition key on.