Denon DVD-5910 - Manual (Page 56)

56
ENGLISH
PLAY STOP OPEN /CLOSE
DVD AUDIO-VIDEO / SUPER AUDIO CD PLAYER DVD-5910
STILL / PAUSE
PURE DIRECT
SELECT
VIDEO MODE
PUSH ENTER
FORMAT SELECT HDMI / DVI SUPER AUDIO CD SET UP
ON / STANDBY
3,4 1 2
12 USING THE VIDEO SETUP
2 The video output setting of the HDMI and the DVI-D connectors can be changed.
2 The video output setting of the PICTURE MODE, TV SYSTEM, SQUEEZE MODE and AUDIO ADJUST also can be changed.
1
Press the HDMI/DVI SELECT button.
• The modes described below will appear on the display.
HDMI/DVI OFF (Factory default)
Not output via the HDMI and DVI-D connectors. Set to
“OFF” when not connecting to these connectors.
HDMI Y Cb Cr
The Y Cb Cr format video signals and audio signals are
output via the HDMI connector.
The RGB format video signals are output via the DVI-
D connector.
HDMI RGB
The RGB format video signals and audio signals are
output via the HDMI connector.
The RGB format video signals are output via the DVI-
D connector.
✽
When connecting to the DVI device via the HDMI
connector, signals are output in RGB format
regardless of whether “HDMI Y Cb Cr” or “HDMI
R G B” is set.
Main unit
SELECT FORMAT
HDMI / DVI
Display the setting mode
✽ The HDMI and DVI indicators flash when the connection is being
checked, then stop flashing, once the check is completed.
HDMI/DVI OFF
HDMI Y Cb Cr
HDMI R G B
2
Main unit
SELECT FORMAT
HDMI / DVI
480P/576P
720P
1080i
SELECT FORMAT NTSC/PAL
AUDIO SUBTITLE ANGLE
HDMI/DVI OPEN/
SUPER AUDIO
CLOSE
CD SETUP
PROGRAM /DIRECT
CLEAR
CALL SEARCH MODE
DISPLAY TOP MENU
RETURN MENU
PLAY STILL/PAUSE STOP
BACK LIGHT
POWER OFF POWER ON
1
2
Remote control unit
HDMI/DVI
SELECT FORMAT
Remote control unit
HDMI/DVI
SELECT FORMAT
Press the HDMI/DVI FORMAT button.
• The modes described below will appear on the display.
Select the item you wish to set and define it.
480P/576P (Factory default)
Outputs the image via the HDMI or DVI-D connector
at 480P or 576P.
720P
Outputs the image via the HDMI or DVI-D connector
at 720P.
1080i
Outputs the image via the HDMI or DVI-D connector
at 1080i.
AUTO
The performance of the HDMI device connected to
the HDMI/DVI-D connectors is detected automatically
and the signals are output according to the HDMI
device’s panel resolution or maximum resolution. The
panel resolution or maximum resolution is selected
according to the setting made at “HDMI AUTO
FORMAT” in the initial settings. (By factory default
this is set to “PANEL RES.”(see pages 33, 36.)).
When a DVI device is connected, the signals are
output with a resolution of “480P/576P”
automatically, so set the resolution manually.
AUTO
ENGLISH